Make-noise FXDf Manuel d'utilisateur télécharger pdf (Page 9)

PATCH IDEAS

( cont’d )

Click and Pop Beat Box patch (requires FXDf normalled to RxMx)

-Record Loop into Phonogene.

-Patch Phonogene Out to FXDf 12db In.

-Set Phonogene Gene Size to NOON, and later adjust to taste.

-Patch master clock or division of master clock to Gene Shift.

-Set PhonogenH Vari-Speed to taste.

-Generate Cycling Function using either MATHS or FUNCTION module.

-Set Rise to about 1 o' Clock and Fall to about NOON, and later adjust for variation.

-Patch non-inverted Output from MATHS/FUNCTION Channel used to the RxMx Channel SELect CV In 1.

-Set CHANNEL panel control to Full CCW. Set CH SEL Attenuator to 5 o' Clock.

-Set RADIATE to Full CCW.

-Patch master clock or gate sequence to RxMx Strike In and Set LEVEL to Full CCW. Monitor RxMx Out B.

Now adjusting Rise and Fall times will generate variations. Adjusting Gene Size and Vari-Speed will vary

the timbre. Use RxMx CH. Input Attenuators to adjust the mix.

Frequency Dependent FM

-Patch Modulating VCO Triangle or Sine to FXDf 6db or 12db IN.

-Select Bands to patch to FM Destinations (carriers) such as the Linear and/ or Expo FM Inputs on the

DPO or STO.

-Patch note sequence to the Modulating VCO (and Carrier VCO as well if used).

As note sequence changes fundamental of the Modulating VCO, the different bands of the FXDf will

produce more or less signal power and thus the FM Index will increase or decrease at each band output

depending upon the frequency of the fundamental.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Make-noise FXDf Manuel d'utilisateur Page 9